Lanolin Gold Marine Wax Antifoul
The
newest generation of Lanolin Gold Marine Wax Antifoul utilises
erodible coating technology to deliver a self polishing, environmentally
friendly coating, that does not allow organisms to adhere to it.
Some
common situations that will benefit from the application of Lanolin
Gold Marine Wax Antifoul include :
- Propellors
- Hulls
- Stern
Legs
- Outboard
Leg
- Bow
Thrusters
- Intake
pick-up gates
Available
in 100g, 500g, 1kg, 4kg, and 10kg containers.
Directions
for use
For
ease of application please note
:- As per coating instructions, one coat is equal to the thickness
of a piece of paper. Four coats equals the thickness of 4 pieces
of paper.
Coatings
:-
- For
racing craft apply one coat thickness ever three to six months.
- For
craft that are permanently in the water but seldom used, apply
a two coat thickness every six to twelve months.
- For
commercial craft and maximum strength apply a four coat thickness,
this can be applied as one coat about the thickness of 4 pieces
of paper.
Reapply as required, as a guide, a 4 coat thickness should last
up to twelve months in use.
Coverage
on a smooth surface :-
- One
coat thickness covers approximately 20 square metres.
- Two
coat thickness covers approximately 15 square meters.
- Four
coat thickness covers approximately 10 square meters.
Lanolin
Gold Marine Wax Antifoul can be applied as a wax in solid
form or heated to become a liquid / paste.
Applying in wax or solid form :-
- Hulls
or large surface areas - apply in wax form using a broad spreading
knife.
- Propellers
- heat propeller with blow torch until hot to touch, apply with
a putty knife as if buttering bread.
Applying in liquid or paste form :-
Put
Lanolin Gold Marine Wax Antifoul into a standard paint
tray and leave in the hot sun until it melts into a liquid paste
form, use a standard paint roller (a short nap wool roller is
ideal) and roll onto the surface as if painting. Use a paint brush
to apply to edges and areas that are difficult to roll.
Lanolin
Gold Marine Wax Antifoul can also be applied in liquid form
by spray or brush.
Propellers
should still be heated or at least hot from the sun prior to application
and then Lanolin Gold Marine Wax Antifoul (in liquid form)
should then be applied by brush to the propeller surfaces.
In
colder conditions put Lanolin Gold Marine Wax Antifoul
into a steel container and indirectly heat the container until
the wax turns into a liquid. Do not apply any direct flame to
the Lanolin Gold Marine Wax Antifoul as that may damage
the product.
The
best results are achieved when applied in hot sunny conditions.
The vessel surface should feel warm or hot to the touch.
Re-application
:-
- Re-apply
at least every 12 months
- Simply
hose down the craft to remove any slime build up and reapply
as directed above.
Clean
Up :-
- For
spray guns use any standard white thinners or turps.
- For
all other equipment use any standard white thinners or turps.
- For
best results and for completely removing Lanolin Gold Marine
Wax Antifoul use Lanolin
Gold Citrus Power Clean.
Here
are some pictures of the Lanolin Gold Marine Wax Antifoul
under an electron microscope
| 
100 times magnification
|
200 Times Magnification
|
500 Times Magnification |
Would
you like to place
an order?
Back
to top of page
